Recent content by bce22

  1. bce22

    Turntable recommendation - MM (Signet TK10ML)

    Thanks for the recommendations! I will definitely look into those tables. I know this cart needs a "light" arm. Anyone else use these types of MMs that can recommend an upgrade path for me?
  2. bce22

    Supercharged - Maverick Audio TubeMagic D2 DAC

    I can't believe this thread has lasted all these years!!! I'm still rocking my Maverick and the Tesla tube. It's a great, great value!!!! Love the fact that all of you are enjoying this highway robbery of a DAC.
  3. bce22

    Turntable recommendation - MM (Signet TK10ML)

    Good Evening, I have an original Thorens TD-160 MKII turntable and I have a Signet TK9ea with a new Signet TK9lca stylus and a replacement TK10ml stylus waiting in the wings. This is a very high quality MM cart/stylus setup being held back by my table/arm. I'm looking for recommendations for...
  4. bce22

    Lafayette KT-550 - Help bypass/disconnect bias meter circuit

    Okay, update. so the 10ohm 1 watt resistors are installed with the original wires running to pin 8 disconnected and tied off. The bias pots work and I am able to bias the output tubes to .50v to get 50ma on each tube. The selector switch no longer does anything. The bias pots all work with...
  5. bce22

    Lafayette KT-550 - Help bypass/disconnect bias meter circuit

    Got it! There are ground points that I can use for the resistors directly without the need of a wire. So if i understnad correctly, all I need to do is disconnect the original wiring in pin 8 that goes to the switch and tie it off. Correct?
  6. bce22

    Lafayette KT-550 - Help bypass/disconnect bias meter circuit

    Good Evening AKers, I have a new-to-me Lafayette 550 that I am looking for assistance with setting the bias. The amp is in pretty good working order and has been refurbished, but I have issues with the bias. I purchased new output tubes from Jim McShane and re-wired the pins to work with 6L6...
  7. bce22

    Supercharged - Maverick Audio TubeMagic D2 DAC

    I'm going to be installing the Sparkos Voltage Regulators tonight. It'll be a bit before I provide full listening impressions. I'm interested to hear if there are any sonic improvements over stock.
  8. bce22

    Fisher 400-C Restoration

    As I prepare for the next phase of my restoration, are there any tricks to accessing: 1. The preamp and the RIAA switch areas? 2. The bottom side of the 4 selector switch area and the back of the controls? I have to be honest, pulling the unit further apart without some idea of what steps...
  9. bce22

    Fisher 400-C Restoration

    Got it! Turns out it was my meter. I have a test lead kit that has the quick disconnects that allow for different leads to be connected. The alligator lead wasn't making good contact and I wasn't getting a reading. Turns out that when I switched leads it works! Occam's Razor for sure.
  10. bce22

    Fisher 400-C Restoration

    I know right?, I had the Ohmite Brown Devils already in the house, so I figured I would use them in that location. The Red/Yellow lead is soldered to the grounding tab of the can closest to the rectifier tube. i haven't touched this lead since I installed the can caps and it worked...
  11. bce22

    Fisher 400-C Restoration

    Here are a bunch of pics after the work so far: PS: I am still waiting for my 1uF caps to arrive. Once they come in , the Aerovox .47uF caps are going. On a side note. Interesting to learn that these caps were made in the old whaling town of New Bedford, MA. less than an hour away from my...
  12. bce22

    Fisher 400-C Restoration

    Thanks everyone for all the info and knowledge on the 400-C volume control. I sent a couple of emails to Mark Oppat early in the week. Unfortunately he hasn't responded as of yet. This weekend I spent a good amount of time continuing with my restoration. Previously I had rebuilt the power...
  13. bce22

    Supercharged - Maverick Audio TubeMagic D2 DAC

    I also have obligatto golds here that I might roll in for the output caps and compare them to the Jantzen caps. The Sparkos discrete voltage regulators should be arriving tomorrow. I'm in the process of restoring a Fisher 400-C preamp so I am going to refrain from installing the VRs until after...
  14. bce22

    Fisher 400-C Restoration

    It's confirmed. The issue is in the volume pot. Perfectly balanced when at 100%. What is the solution for fixing the imbalance?
  15. bce22

    Fisher 400-C Restoration

    Yes, it is a great idea. My money is on the volume pot since I can clearly hear a change in the level of imbalance from low volume (worse) and higher volume (better). I'll turn down the volume on my laptop and open the 400-C all the way.
Back
Top Bottom