Recent content by steveUK

Seeing no other way out, I disconnected the front panel. Ha, that's easier said than done as the tuning cord is deployed on both the front panel and the main chassis. Anyway, I allowed the tuning cord to hang loose in the belief that I could sort it out afterwards. That 'kinda' gave me access...

The front panel is 'connected' to the major chassis via the tuning cord plus screws 'everywhere'. So unless the tuning cord is removed (major pain), then it's not possible to remove the front panel, or maybe (it's hard to tell) the panel itself sectionalises and allows the bottom half to come...

That being the case you're saying that the pull in force of the relay is poor/weak. That's either due to the relay not functioning properly (relay coil problems such as intermittent/partially short or open circuit, or a mechanical issue) or, the coil voltage being insufficient ie too low for a...

If - as you say, the contacts on yours are immaculate - just spend a bit more time setting it up so that the contacts operate properly and of course are clean, as they should already be clean from what you say. It will take less time than sourcing and ordering and fitting a new one. And free of...

After a long gap on this subject, I now have the bulbs in question. Has anyone actually replaced any of these input selection lamps/bulbs that are mounted on a long narrow PCB, itself being mounted on the front panel? I've looked long and hard at ways to access them and as yet have not figured...

I recently had a similar tight tuner unit on my 2060L. I used thin silicon lube applied with a fine awl to the front, visible part of the shaft behind the black tuning cord carrier where the shaft appears comprise a number of moving sections that are all sliding over each other. At first this...

A Grundig Satellit 650 works fine on all bands except for the following problem. In motorised mode the set is supposed to drive the tuning cap and dial pointer to a recalled stored station or just dialled in frequency by the keypad. The motor runs and the tuning cap and dial pointer are moved...

I have an original one on the way. Apparently the same strap and connector type was also used on a certain Sony Discman, and that's nowhere near so sought after as the Walkman WM-D6C cassette player. Thanks for your input and ideas guys.

Here's a diagram of the strap and fittings from the instruction manual. You can see that the strap has special clips that form fit the buttons on the side of the player and actually clip on to them. Maybe, just maybe, Sony used the system on another piece of kit?

As it's going to be a very hard task (not to mention cost) to find an original strap for my Walkman WM-D6C, has anyone 'made' or re-used one of another type? The problem is, in order for the strap to be secure it has to firmly embrace the buttons on each side of the player. For example, a...

Hmm, yes that's an idea and I can explain my situation. Thanks.

Actually in continuing to search for this I've come across a US based supplier, wjoe, who actually provides fitting information. The problem is, as soon as I got the machine and realised that it needed new belts I got straight on to Ebay and found a few suppliers in Europe (I live in the UK) and...

Needing to change the belts on a Pioneer CT-93, it occurred to me, how did technicians in Pioneer repair centres manage to do this?! I ask the question because without detailed instructions, the complex electro mechanical ‘lump’ that is called a cassette mechanism is a rather daunting piece of...

Thanks so far guys. I'll report back.

Thanks Watthour. So, stereo decoder section? Out of interest, the service manual does not appear to have the procedure for re-alignment unless I'm missing something? It has a whole host of set up procedures but I cannot see any that are actual re-alignment ones as in "apply this frequency and...