Search results

Thank you.

Does anyone know the hole size for the following Jelco arms? SA-370h TK-850m I looking for the size of the hole to mount the arm. Thanks,

I am looking for the mounting template for a Rek-O-Kut K33H. I cannot seem to locate one. Either a photo of a plinth or a photo of the template (if there ever was one). I will be building a plinth for a gentleman but I don't have the turntable to use for measuring etc. Maybe it is the same as...

There is no existing stylus.

anyone know what EVG stylus fits a Shure Premier cart? I think the cartridge is a M75 but not sure. Thanks,

i recently rebuilt a rekokut Rondine delux with the large Ashland motor. I replaced the lord mounts and had the idler rebuilt as well. The motor turns free and seems to run well but is occasionally dropping speed a bit. It normally runs at 33.1 but drops to 30.1 for no apparent reason. Does...

Thanks all!

does anyone know if a B12H turntable use a thrust washer below the platter spindle? Tks

Oogling is good! Thanks

Hello fellow members. Yep, I’m the guy who built that plinth. If you are thinking about a new plinth, take a look at my FB page for more examples and ideas. Just search for Vintage Analog Restoration. I appreciate the compliments. Flasher1 (Larry)

Perfect! That’s exactly what I needed. Tks

does anyone know how difficult it will be to install an SME 3009 on an Empire 208? Tks!

I have the heavy counterweights you asked about. They are 125grams, the original is 100grams. I sell them for $45 conus. Best of luck with your mods. Larry

I have them if you need one. Nice build buddy. Amazing job.

It’s bent. Needs to be straight.

I am looking for a tonearm for the pioneer listed above. If you have an old junk turntable of that model and we would be willing to part with it please let me know. I’ve also posted this in Barter town. Thank you

Do you care to sell it? I could use the parts. I have a KP-5021 which has many of the same parts. Larry

Double that!

No can do. The bottom of the spindle has a rounded point at the bottom. That point rests on the heist washer. It’s really a thrust disk. That crud that is in the bottom was the old thrust washer. I use a cutting board as they are made of PTFE or something like that and it is very slick and...

Not a PITA at all. It would work better if we could speak and I hate to type on a phone but here goes: The spindle wells both can be removed by the top by removing three screws. Both you don’t really need to because as you’ve already figured out, you can unscrew the bottom. Once you do you will...

I am looking for the one at the far right on the photo above. Does anyone have a link to the correct glider? Not the knockoffs, not the yellow one, the one on the far right with the flat top. Thanks,

That’s two completely different circuits. Not sure how that could be. Maybe a vibration from flipping the switch causes the problem. Weird!

Great!

Can’t hurt.

I’ve used motor oil for quite awhile to clean up the grungy look on these top plates. Wipe on, wipe off. Easy peasy