Search results

Perhaps the cartridge would require a metal housing that must be grounded and a non-metal arm might perhaps be best although a metal (grounded) arm would shield the wiring. Many things to consider!

Wouldn't the cartridge, arm, and wiring will be affected by the resulting magnetics?

On Kickstarter: https://www.kickstarter.com/projects...ting-turntable

So you have tried this no-DAC stuff? What was your implementation?

So you have tried this no-DAC stuff? What was your implementation?

nerdorama, do you happen to have/know a link for the Lampizator that you have mentioned and heard?

SoNic67, I think you are looking at a 1 bit DAC (conversion) approach whereas the NO-DAC approach is using a LPF (Low Pass Filter/NoDac) approach to realize the analogue signal from the DSD pulse bit data?

Hi, I have been reading about feeding 128/256/512 DSD to a board that converts the DSD to I2S (Amanero or JLSounds board) then take the I2S left and right channels and feed through a DC Block then through a LPF which removes the HF carrier/noise. This removes the need for a dac and the opamps...

Netdewt, please add the The Klein DAC, http://www.gieseler.com.au/page2/index.html, to the list :)