Discussion in 'Solid State' started by bully, Aug 10, 2002.
Impressive at 23kg too.
Can we talk new amps here?
This is my new beauty. WOOHOO!
It's a Magnat RV3.
It's a tube pre amp and solid state main amp, the best of both worlds
The heart and control center of the RV 3 lies in the audiophile tube preamplifier, which amplifies the incoming signals directly after the input stage. Fans of vinyl will be delighted by the elaborate phono section with its separate inputs for moving magnet (MM) and moving coil (MC) pickups.
4 high-level inputs
Record Out fixed level output
Bi-wiring output terminal with large, insulated speaker terminals
Discrete high-performance amplifier with high quality power transistors from Toshiba
Output rating of 200 watts of sine power per channel (4 ohms)
Low-noise tube amplifier with 2 x 12AU7 / ECC 82 tubes
Preselected and burned-in (60 hours) tubes produced in Russia
Phono preamplifier with separate MM / MC inputs, low-noise operational amplifiers and subsonic filters
Input signal switching via high quality reed relays
Low-loss WIMA audio capacitors in the signal path
Output power / Nominal: 20 Hz – 20 kHz, THD < 1.0%,4 Ohm, 2 x 200 W, 8 Ohm, 2 x 150 W
Peak: 1 kHz, 4O: 2 x 350 W
Power consumption: Max 650 W
Mains voltage: 230 VAC / 50 Hz
CD/Tuner/Aux/Line/Tape: 110 dB
Phono MM: 90 dB
Phono MC: 78 dB
Dimensions (WxHxD) 434 x 155 x 360 mm (410 mm incl. control elements)
Weight 19.5 kg
CD/Tuner/Aux/Line/Tape: 20 Hz – 20 kHz (+/-0,2 dB)
Phono: 20 Hz – 20 kHz (+/-0,2 dB)
Phono Subsonic Filter: 16 Hz, 18 dB/Oct.
CD/Tuner/Aux/Line/Tape: 5 Hz – 110 kHz (-3.0 dB) 20 Hz – 20 kHz (+/-0.1 dB)
Phono MC: 0,3mV/470O
Phono MM: 3mV/47kO
kenwood km 209 150rms channel power amp
Separate names with a comma.