Sorry, I don't have Pics yet, but it really sounds good! The JBL2600s (connected to Speakers B) did'nt have quite all the bass I had hoped, but I also connected some KLH 120 as Speakers A, and using both, the unit was very impressive. It has a large volume control in the middle that goes from 0 - 100. I never got it past 10 as it was too loud. Everything seems to work OK on this Sanyo 2050, but there are a few things that I noticed that seem a little unusual. To tune the FM, I found that it was better to turn off the FM Stereo, and then to tune in the station using the tuning meter. The Signal Strength meter seems to only work on some really loud and obnoxious AM stations. Once an FM station was tuned in though, after a few seconds, the green quartz-lock light would come on indicating that the station was locked, and then I switched it back to FM stereo. This was all using the built-in little FM tube Antennae on the rear of the unit. All of the function lights seem to work, but the radio dial is not lit, not even the selector needle. I've replaced light fuses on an old Superscope receiver in earlier days, but don't know if this one has lights that need to be replaced, or if that is just the way they were made. The Power meters, Signal Strength, and Tuning meters are all lit. Did I mention it sounds great! Even the wife and cats liked it! I've read some online info (what little I could find that suggest that this receiver is 50 WPC. That sounds about right. I'll get some pics and post later.