Having nearly the same problem as described for the traditional EMIT.
I cant resolder the terminals on the EMIT-R folio. Picture attached.
While remelting the solder i cant make it "bite" again. Do anyone of you know about cleaning the joint so that the solder can "bite" like normal ?
It seems that the flus in the new solder is not enough.
Im affraid to turn up the heat to much on my soldering station and "roast" the diaphragms itself.
Ideas are much appriciated. It seems to be "cold soldering" from the beginning, and to resold the other tweeter would be a good thing to do in the same operation.
Thanks
Jens
I cant resolder the terminals on the EMIT-R folio. Picture attached.
While remelting the solder i cant make it "bite" again. Do anyone of you know about cleaning the joint so that the solder can "bite" like normal ?
It seems that the flus in the new solder is not enough.
Im affraid to turn up the heat to much on my soldering station and "roast" the diaphragms itself.
Ideas are much appriciated. It seems to be "cold soldering" from the beginning, and to resold the other tweeter would be a good thing to do in the same operation.
Thanks
Jens