Mx-1000

are thay hard to install

Depends what your definition of hard is.

The more difficult part is to get the old bulbs out without damaging the red rubber booths. They are unobtanium, keep that in mind.

If you happen to damage them, then you may need to consider replacing the bulbs with LEDs.
 
Depends what your definition of hard is.

The more difficult part is to get the old bulbs out without damaging the red rubber booths. They are unobtanium, keep that in mind.

If you happen to damage them, then you may need to consider replacing the bulbs with LEDs.

what type of led could i use
 
Depends what your definition of hard is.

The more difficult part is to get the old bulbs out without damaging the red rubber booths. They are unobtanium, keep that in mind.

If you happen to damage them, then you may need to consider replacing the bulbs with LEDs.

Usually the boots in a MX1000 are in pretty good shape. They don´t crumble like the older stuff.And they are not unobtainium.
 
Usually the boots in a MX1000 are in pretty good shape. They don´t crumble like the older stuff.And they are not unobtainium.


They tend to stick to the old bulbs and break even with most careful handling...

Where can I get a set from?
 
Probably due to using the incorrect replacement lamps at one time or another.
 
Back
Top Bottom