Time to pull the 2020's Power Supply & Electrolytic PCB's
Okay, thought I would start a new thread for this which was mentioned in a previous post of mine. Merrylander I would like to take you up on the offer of sending me the drawings/masks of these two boards as a friend of mine has agreed to see if he can help me etch new ones. Also as I remove the boards is there a preferred method for disconnecting the wires? Should I desolder the soldered connections and cut the wire wrapped connections to be resoldered and shrink wrapped later as I read somewhere on this Board that the wire wrap pins are an odd size which makes finding a suitable gun difficult. I will need to remove all wires that are connected to both boards and just wanted to know how the experts would handle this procedure. I also E-mailed mike@vintageaudiomanuals.com yesterday mid-day for details on purchasing a service manual but have not received a reply yet. Any input as I head down this unfamiliar path will be greatly appreciated. Thanks.
Okay, thought I would start a new thread for this which was mentioned in a previous post of mine. Merrylander I would like to take you up on the offer of sending me the drawings/masks of these two boards as a friend of mine has agreed to see if he can help me etch new ones. Also as I remove the boards is there a preferred method for disconnecting the wires? Should I desolder the soldered connections and cut the wire wrapped connections to be resoldered and shrink wrapped later as I read somewhere on this Board that the wire wrap pins are an odd size which makes finding a suitable gun difficult. I will need to remove all wires that are connected to both boards and just wanted to know how the experts would handle this procedure. I also E-mailed mike@vintageaudiomanuals.com yesterday mid-day for details on purchasing a service manual but have not received a reply yet. Any input as I head down this unfamiliar path will be greatly appreciated. Thanks.
Last edited: