BBRN
Well-Known Member
I just completed a full recap on a CR1020. Reassembled everything and powered up on a dim bulb with a 25w bulb. The bulb stays bright. I unfortunately due to disassembly was not able to check my work as I went along from board to board. I was EXTRA careful when dealing with polarities, and went one cap at a time. I have checked all of my solder connections...everything seems good. Fuses are all good. I used a new Omron MY2-02 relay which is not engaging. The only thing I'm unsure of is there are 2 caps on the PS board both 3.3uf 25v. I used bi-polar caps in these spots. Would the non-polarized caps be causing my problem?
Thanks for any help anyone can offer in isolating this...always a bummer when that light stays on:worried:
Thanks for any help anyone can offer in isolating this...always a bummer when that light stays on:worried: