Cadillac Kid
Addicted Member
I have a CA-2010 that has a problem. Right channel is dead with an intermittent loud pop(think gun shot). Then it goes into protection.
I have cleaned the coupler switch
Checked DC offset
Cleaned all other controls.
Injecting a signal into the main amp section while the preamp is switched out does not affect the problem. So I think I can focus on the main amp as the source.
I have the circuit diagram and a pretty good basic test bench.
Any suggestions on the next step for tracking to the issue? I would love to get this beautiful amp working.
Thanks for any assistance.
I have cleaned the coupler switch
Checked DC offset
Cleaned all other controls.
Injecting a signal into the main amp section while the preamp is switched out does not affect the problem. So I think I can focus on the main amp as the source.
I have the circuit diagram and a pretty good basic test bench.
Any suggestions on the next step for tracking to the issue? I would love to get this beautiful amp working.
Thanks for any assistance.