ilikeguitars
New Member
Recently picked up this receiver from the local goodwill and it seems to be in working order, both left and right speaker outputs are fine. Upon opening it up i noticed the burned looking area on the power supply board. the resistors are 330 ohm 2W and seem to run way too hot. I have little experience with restoring vintage receivers and wanted to know if i could possibly change these resistors to higher wattage and if it would help at all. Also can anyone point me in the direction of how i would change the lamps to LEDs, if its not to much work. If anymore information is need hopefully i will be able to supply it.
Front
Back
Service manual diagram red area is of concern
parts list
PDF of service manual
Front
Back
Service manual diagram red area is of concern
parts list
PDF of service manual