CR-1020 Fusistor issue

Hi
As per service bulletin i've tried to change out the fusistors on the upright board with the coke cans for 3w 22ohm, however my replacement parts are much larger and rectangular which stops the relay board plugging back in.

I'm in the UK so Mouser isn't really viable, can anyone point me in the right direction? Can I use 3w 22 ohm resistors instead?!

Thanks in advance

Dom

Welcome to AK... These should do the trick.



http://uk.farnell.com/panasonic-ele...resistor-metal-oxide-22ohm-5-axial/dp/2324560

Brilliant, thanks Avionic, I'll get those ordered.

Another question, the 22 and 10 ohm fuse are bridged by solder at one point on the board, is this correct? I assume it is since the amp was running ok

Thanks

Dom