CR 2020 Balance knob out of alignment/faulty

Basil959

New Member
Hi,

I recently purchased and restored, lamps, caps and cleaned a CR2020.

I removed the volume and balance knobs, cleamed and pushed them back into place, but there seems to be a problem, I center it on "10" then rotate it to "1" but it goes past "1" and then stops short of "10".. can't figure it out. Stripping the pots seems like a massive job.. Any advise?
 
Pull the knob off. Turn the spindle to it's center detent and then replace the balance knob with the mark on the center mark. If there is no center detent then you will just have to reseat the knob on a trial and error basis until you get it right.
 
Hi,

I stripped all the knobs off the front to clean, etc...

My problem is the balance pot seems to be damaged, I center the knob but when I turn it full left then full right it goes off center, by that I mean the indicator "dot" stops on 1 but after I turn it right then back left it over shoots 1 and when I turn it back to the right it stops short of 10.. very strange....
 
Is there a plastic insert in the balance knob ? If so it needs to be reglued.Its slipping.
 
Back
Top Bottom