Hi,
I recently purchased and restored, lamps, caps and cleaned a CR2020.
I removed the volume and balance knobs, cleamed and pushed them back into place, but there seems to be a problem, I center it on "10" then rotate it to "1" but it goes past "1" and then stops short of "10".. can't figure it out. Stripping the pots seems like a massive job.. Any advise?
I recently purchased and restored, lamps, caps and cleaned a CR2020.
I removed the volume and balance knobs, cleamed and pushed them back into place, but there seems to be a problem, I center it on "10" then rotate it to "1" but it goes past "1" and then stops short of "10".. can't figure it out. Stripping the pots seems like a massive job.. Any advise?