quartersaw
Super Member
Looking down the list of caps for the Mc2300.
C3,C4, and C201,C202 are .47uf/250V. Mylar caps. I assume that I should replace with same,(?) or are there 'better' alternatives? I had a replacement 80/80/150/50uf can cap made. I'm going to replace the board caps first before I even think about the cans. Terry Mentioned Nichicon caps some time ago, but I can't seem to find the correct values. Any vendor suggestions?. As always, thanks for your advice!
C3,C4, and C201,C202 are .47uf/250V. Mylar caps. I assume that I should replace with same,(?) or are there 'better' alternatives? I had a replacement 80/80/150/50uf can cap made. I'm going to replace the board caps first before I even think about the cans. Terry Mentioned Nichicon caps some time ago, but I can't seem to find the correct values. Any vendor suggestions?. As always, thanks for your advice!
Attachments
Last edited: