When shutting off my Yamaha CR-620 receiver, a pop comes through the speakers a few seconds after powering off. The volume of the pop is the same regardless of the volume setting. It happens in both speakers whether on the A or B outputs. There is minimal voltage across the speaker terminals except for a 1 volt reading from the pop (not sure the multimeter captures the peak though). Other than that the receiver works well and sounds great.
I've searched through recent posts but didn't find any conclusive approaches.
Since the pop is not that loud, I also wondered if it was acceptable as is or is something that can damage speakers or other circuitry.
Any thoughts would be appreciated.
I've searched through recent posts but didn't find any conclusive approaches.
Since the pop is not that loud, I also wondered if it was acceptable as is or is something that can damage speakers or other circuitry.
Any thoughts would be appreciated.