switch

It has been a while since my last post, but that does not mean I haven't been busy..... Currently working on a Sansui AU-555 which was totally neglected by the previous owner. I am trying to make her beautiful and working again, and for that I need your help. Unfortunately I cannot get the...

Power LED on Adcom GFA5800 is out. How to replace, what part, etc. Thanks a million to anyone who can help!!

I have a spare Sansui 7070 I ordered from eBay quite a number of years ago. When it arrived the speaker selector switch was badly bent. UPS Insurance reimbursed the cost so it was free. After it sitting in the basement for 8 years or so I dug it out and fired it up yesterday and it works and...

Push pull switches. When servicing can anyone advise on best lubricant for these switches in vintage amps. Ideally, a homemade recipe as I just need to disassemble and regrease one switch. Can petroleum jelly be used? Thanks in advance.

Hi, I need to replace the broken start switch of a Dynacord IST 104. The original model is a Dialistat 2-pole type (DPDT), same as the one pictured below but with a larger metal holder allowing screwing it to a metal plate, itself attached to the metal body of the turntable. The blue plastic...

Hello all. This is a long shot I feel but I have come into possession of this project one receiver that is in immaculate condition. The only problem is the high tone switch was broken at some point. I’m now trying to open it up and repair it. I have added two pictures below but I’m unsure how...

Hi y'all, Firstly, sorry to bring out this old question again, but recently I just received this inquiry from my friend who is also on his way to digital streaming though, as we were discuss whether a network switch would help or not like everyone else, he sorta struck me with this, " Based on...

Hi guys, So I've been meaning to ask if there's an optimal way to stream these streaming service, if you know what I mean..., like some players which directly support TIDAL or Qobuz or Amazon Music and stuff, but what if I stream TIDAL through Roon, would the sound quality get better? and why...

Any ideas on where to buy a toggle switch cover (small piece that is at the tip of each switch)? Mine is forever lost since it came un-glued and is so small.

Hi guys, When it comes to sound quality, I've realized there're freaking many factors could affect it, some say the DAC is the paramount thing to be taken care of; some say the speakers are the real crucial part, given that you hear all the sounds from them, there's no certain right or wrong...

anyone know of a source for this switch ? I am missing the power on/off switch from Sansui AU 101. Thank you.

I think it's been a quite controversial topic for years, like what's the difference between normal network switch and an audio grade network switch, the price difference is certainly obvious though... Anyway, I've done some researches, most audio reviewers say that under this " new digital...

I was facing a job involving rewiring of the 500C’s 7-position 5-section selector switch and realized I did not have near the understanding I needed to feel good starting. To help myself get there I put together 7 drawings to show the state of the network and signal path for each switch...

HI, I have dozens and dozens of switches laying around of all different ratings and I was wondering what the ideal rating would be for voltage/amps for a on off power switch for a marantz model 32 power amplifier. Thanks

Hello everyone, been a while since posting, but I troll a lot because this forum is a great resource. My AU-11000 recently quit working, and the guy looking at it believes it’s the input switch. It turns and clicks, but the piece that actually changes connections is not moving. Does anyone know...

All, Looking for a modern replacement for the the ALPS slide switches in an 1180DC (also used on the 1152 and 1300, probably others too). Marantz part numbers SP04010210 and SP04040170 (15Hz and tone defeat switches). There are not the same design as the F4UEE switches. Thank you!

Greetings, A very close friend from high school convinced me to go the Hafler route many years back and I purchased both a DH-110 preamps and XL-280 (both in kit form) just about 35 years back. Though I've had a few minor connectivity issues arise over the past few years with the DH-110, the...

Hi, Is there a model of power switch which fits the Luxman L-31 ? As I don't have the amp with me right now, I can't even try to see what can directly replace it. Thanks !

After reading threads from in my case audioKarma member Kale, being amazed about how far he takes the restoration process and recently by Bumpalump I decided I will have to learn this side of the game too. Because I can not just go taking apart mostly unreplaceable potentiometers and switches I...

Hi I got my 5th receiver in .... It is a nice little SONY STR 6046 Goal is to restore it to be functional and keep it in my personal collection. Upon first check The Amp does run fine, but the reciver part (AM a FM) is not functioning. Also AUX and Phono only give one channel.. On further...

hi, im looking for the phono 1 switch or the entire selector switch bank...right in the middle of helping out with a restore, and this part is desperatly needed...thanks for your time and have a great one...it is part #S201-452-2002-000, made by Alps...i dont know if there is another switch that...

Hi all, thank-you in advance for any advice received. I recently purchased a ka-4002 from the original owner, in very nice condition (incl. user manual and wood trim). I'm really enjoying the sound coming through it, but have the following issues I'd like to fix: a) Once powered on, there is a...

Hey all! I have browsed this site for a while, but today is the day of my first post as I am in need of some assistance! I have been trying to repair a TEAC A-500 cassette deck for a while now without success. My issue is this: The deck auto pauses like it's trying to make its own music...

Where canI find a switch tip to replace the missing one for this unit? Links and advice will all be appreciated. BACKGROUND: I bought my beautiful CR-1000 on eBay several years ago. It's plays beautifully and LOUD. Only problem is aesthetic - one of the switch tips is missing. It came to me...

Hi forum, I've just signed up. I do a lot of restoration of old hifi gear. I probably should have signed up ages ago. But nevertheless I like the look of this forum and hope to contribute and gain from the experience. I have just completed restoration of a Goodmans One Ten that I bought for...