Bad designs are often found in absolutes. Adjustments or the ability to adjust makes for a better design. If it were my arm, the holes would be replaced with slots. Why design in absolutes when you seem to still have so many questions.
Bad designs are often found in absolutes. Adjustments or the ability to adjust makes for a better design. If it were my arm, the holes would be replaced with slots. Why design in absolutes when you seem to still have so many questions.
Like I said above, that will come in later versions, when I attempt to bring the stylus inline with the pivot (vertically) w/o disrupting the center of gravity too much.
In the meantime, cartridges with 9.5mm (3/8") stylus to holes are everywhere, it is by far the most common measurement.
You guys need to keep in mind I still need to make my first iteration of my table itself. Lots of work to do, I can't get bogged down in any single detail now, not unless I know it is going to stop me from moving forward.
Edit to add: Don't take the fact that I'm not changing my design NOW as disregarding what you're telling me, I'm just prioritizing. I'll come back to it. You'll know when I do from all the questions I ask (insert diabolical laughter here).
