G'day all, in general terms I'm very happy to see that vinyl records are popular again as evidenced by the burgeoning market for 'outboard' phono stages going from quite inexpensive to 'very' expensive.
As I mentioned in another thread the other day I seem to have acquired a few phono stages and it is interesting that I rate quite a inexpensive one rather highly.
In the past I have mentioned my general dislike for full feedback op amp based phono stage. These are popular and most of the designs available seem to use that general circuit approach. They work well but I personally do not 'like' their general sound quality. They are quite 'adequate' though and some have useful refinements like switchable input capacitance loading.
My 'tick' goes to the TCC TC-750. Although it has a very different sound to my reference DIY ESP P06, I find that TCC TC-750 a very smooth, musical sounding and 'listenable' phono stage with a free uncompressed sound, a trait I rather like. It is entirely based on discrete transistor circuitry and that appeals to me.
I'll admit that there was a time when I was very 'anti op amp', at least until I built my first DIY ESP P06 phono stage, and that completely changed my mind about op amp circuitry. It uses op amps in a very clever circuit. The P06 has made me realise that op amps aren't the problem, it is the circuit design in how they are used, in my opinion.
Anyway the TCC TC-750 is a well made unit with high quality soldering and good quality compoments. Metal film resistors are used (mandatory in low noise applications, in my opinion), good transistors and the capacitors are good quality. There are a few electrolytic capacitors in the signal path but that isn't a problem as I see it. After all, so does the ESP P06!
The only real quibble that I have about the TCC TC-750 is the supplied wallwart which is of the 'switch mode' variety and it does produce audible (prickle) noise in the output (at least mine did). I have changed mine to run off a 12 volt DC gel cell battery and the noise floor is now superbly quiet, and is a delight to listen to. I've also changed the input loading capacitors from 220 picofarads to 100 picofarads WIMA polypropylenes, mainly to optimise the overall capacitance loading with my M97xE.
As I've said before it has a different 'sound' to my DIY ESP P06, but is no less enjoyable to listen to. Each to their own of course, but purely on the basis of non fatiguing sound quality, I regard the TCC TC-750 as very nice and is recommended in a new vinyl playback system. Its price may be budget, but its performance is anything but! Regards, Felix aka catman.
As I mentioned in another thread the other day I seem to have acquired a few phono stages and it is interesting that I rate quite a inexpensive one rather highly.
In the past I have mentioned my general dislike for full feedback op amp based phono stage. These are popular and most of the designs available seem to use that general circuit approach. They work well but I personally do not 'like' their general sound quality. They are quite 'adequate' though and some have useful refinements like switchable input capacitance loading.
My 'tick' goes to the TCC TC-750. Although it has a very different sound to my reference DIY ESP P06, I find that TCC TC-750 a very smooth, musical sounding and 'listenable' phono stage with a free uncompressed sound, a trait I rather like. It is entirely based on discrete transistor circuitry and that appeals to me.
I'll admit that there was a time when I was very 'anti op amp', at least until I built my first DIY ESP P06 phono stage, and that completely changed my mind about op amp circuitry. It uses op amps in a very clever circuit. The P06 has made me realise that op amps aren't the problem, it is the circuit design in how they are used, in my opinion.
Anyway the TCC TC-750 is a well made unit with high quality soldering and good quality compoments. Metal film resistors are used (mandatory in low noise applications, in my opinion), good transistors and the capacitors are good quality. There are a few electrolytic capacitors in the signal path but that isn't a problem as I see it. After all, so does the ESP P06!
The only real quibble that I have about the TCC TC-750 is the supplied wallwart which is of the 'switch mode' variety and it does produce audible (prickle) noise in the output (at least mine did). I have changed mine to run off a 12 volt DC gel cell battery and the noise floor is now superbly quiet, and is a delight to listen to. I've also changed the input loading capacitors from 220 picofarads to 100 picofarads WIMA polypropylenes, mainly to optimise the overall capacitance loading with my M97xE.
As I've said before it has a different 'sound' to my DIY ESP P06, but is no less enjoyable to listen to. Each to their own of course, but purely on the basis of non fatiguing sound quality, I regard the TCC TC-750 as very nice and is recommended in a new vinyl playback system. Its price may be budget, but its performance is anything but! Regards, Felix aka catman.
Last edited:
I have many more cartridge lash-ups to test against this one too :scratch2: